Aluminum Die Casting Parts Draft Angle – Draft Angle in Die Castings

When someone asks me “what is draft angle in a box?” or “why do I need a draft angle on my aluminum die casting box part?” The technical answer is, all aluminum die castings require a draft angle on the walls of die cast box parts perpendicular to the parting plane or parallel to the slide interfaces. Since I have selling die cast parts for over 20 years, I find simple answers and provide simple calculations for my customers. What does that mean to the typical engineer (any engineer other than tooling or mechanical) or professional buyer?

I try to give examples that most people can relate to, because most people do not have a need to concern themselves with how things are made, only what is made, and will it be what they need. I ask, “Have you ever noticed on a cupcake the bottom diameter is smaller that the top diameter?” or “Have you noticed that a cake pan has sides that slope in toward the middle of the pan?” That would be an extreme example of a draft angle. Aluminum die castings would stick inside the die casting tool, molds, or die casting die if there was not enough draft angle in the tool and part. The typical draft angle for an aluminum die casting part is two degrees per side. The calculation for that is simple if a person is familiar with die casting production part design, but is not familiar to most people.

Picture an enclosure (or Aluminum Box) sitting on a table with the open side up. The aluminum box is 2″ deep inside with the height and width 4″ each way on outside. The walls of the box are 0.10″ thick. Due to the wall thickness, a few things are evident to a part designer concerning this simple box:

• The overall height of the box is 2.10″ tall.
• The interior of the box at the top of the opening is 3.80″ x 3.80″.

A 2 degree draft angle will change the dimensions in the following on the interior and exterior and should be considered if something needs to fit inside the box or outside the box:

• The top inside dimension of the box will be 3.80″ and the bottom inside will be 3.664″
• The top outside dimension of the box will be 4.00″ and the bottom outside will be 3.864″

If the box was designed for the interior of 4″ x 4″ at the bottom: box:

• The top inside box dimension needs to be 4.136″
• The outside top box dimension will be 4.336″.

See webpage: http://www.kineticdiecasting.com/draft.html

Kinetic Die Casting manufactures a lot of aluminum rooftile plates , trim tile molds, and military die casting. If you would like a quote, please visit our website: Kinetic Die Casting Company